VNU-UET Repository

Pressure sensor based on bipolar discharge corona configuration

Thanh Van Dau and Thanh Tung Bui and Xuan Thien Dinh and Tibor Terebessy (2016) Pressure sensor based on bipolar discharge corona configuration. Sensors and Actuators A Physical . pp. 81-90. ISSN 0924-4247

[img] PDF
2MB

Abstract

We present a pressure sensing unit based on a unique corona discharge setup using symmetrical electrode arrangement with simultaneous positive and negative corona generation. The device generates stable corona discharge and enables reliable air pressure measurement in the range of 80-105 kPa, tested with five prototypes. The current-voltage characteristics of bipolar discharge system is analyzed in general form and three governing parameters, namely electrode geometry, electrode distance and discharge current, are studied in relation with absolute pressure. The sensors are driven with constant discharge current as low as 1 μA. The measured sensitivity is in good agreement with theoretical prediction and the sensor stability has been confirmed with 20-h continuous test without sensitivity deterioration. The sensitivity does not depend on the tested temperature range and its variation between devices is small, approximately ±3.0%. The advantage of the proposed system compared with similar corona-based constructions is its stable operation at low current with low power consumption and minimum electrode deterioration, which provides a cost effective and reliable solution

Item Type:Article
Subjects:Electronics and Communications
Electronics and Communications > Electronics and Computer Engineering
ISI/Scopus-indexed journals
?? scopusjournal ??
Divisions:Faculty of Electronics and Telecommunications (FET)
ID Code:1582
Deposited By: Assoc/Prof Duc Tan Tran
Deposited On:24 May 2016 01:36
Last Modified:31 Dec 2016 14:17

Repository Staff Only: item control page